Basic Application - WEG CFW300 Manual Del Usuario

First Time Power-Up and Start-Up

5.2.1 Basic Application

Seq Display Indication/Action
Initialization mode
1 „
Press key to enter the first level of the
„
parameterization mode
Press keys or
„
3
If necessary, change the content of "P101 -
„
Deceleration Time"
Use key to select the parameter P133
„
5
If necessary, change the content of "P134 -
„
Maximum Speed"
Press key for the next parameter
„
7
If necessary, change the content of "P296 – Line
„
Rated Voltage" (only for 400 V Line)
Press the key until selecting parameter P002
„
9
Press key that the motor will accelerate up to
„
3.0 Hz (factory default setting of P133 - Minimum
Frequency)
Press and hold it until it reaches 60.0 Hz
„
11
When the motor stops, the display will indicate
„
"ready"
30 | CFW300
to select the parameter P100
Figure 5.2: Sequence for basic application
Seq Display Indication/Action
2
Press key if you need to change the content
„
of P100 - "Acceleration Time" or press key
the next parameter
4
If necessary, change the content of "P133 -
„
Minimum Speed"
Press key for the next parameter
„
6
If necessary, change the content of "P135 - Output
„
Maximum Current"
Press key to select parameter P296
„
8
Press key to view the parameter content
„
10
Press key . The motor will decelerate to a stop
„
for