CASO DESIGN Slow Juicer Manual De Instrucciones página 46

17.2 Troubleshooting
Problem
The device does not start.
The amount of juice is very
little and residues are still
damp.
The device stops during
operation.
There is too much pulp in
the juice.
The feeding tube will not
close.
Dying of the plastic parts.
► If above mentioned steps don't solve the problem, please contact your customer
service.
► Please clean the device before sending it to customer service.
18 Disposal of the Old Device
Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety. If these were put in the non-recyclable waste or
were handled incorrectly, they could be detrimental to human health and the
environment. Therefore, do not put your old device into the non-recyclable waste under
any circumstances.
Solution
 Please check whether the plug is properly plugged in.
 Please check whether the device is assembled correctly
and lid is closed.
 The device must not be used for very hard fruits or
vegetables.
 Different ingredients hold different amounts of fluid that will
yield different amounts of juice.
 Check if all parts were assembled correctly.
 If juicing ingredients with small seeds, after a few servings,
it may reduce the juice yield.For best result, disassemble
and wash the top-set (without motor block) in between
juicing.
 Use REV-function and follow the instructions in "If the
device stops during operation"
 Use a mesh strainer and put the juice through it to collect
the unwanted pulp.
 If too many ingredients are inserted at the same time, it
may cause the juicer to stop frequently. This can lead to
pulpy juice. Insert the ingredients slowly and few at a time.
 Make sure that the feed auger is engaged properly so the
feed tube closes properly.
 After juicing, if the juicer is not cleaned right away, the
remaining pulp inside the top-set can dry up which can
make disassembling and cleaning hard. This can also
affect the juicer's performance and color.
 Ingredients which are rich in colorants, for example carrots
or spinach, may dye the plastic parts. The dying does not
affect the device.
Please note
46