Publicidad
Idiomas disponibles
Idiomas disponibles
Disconnect battery pack from tool before assembly, adjustments, trouble-
shooting or changing accessories . Such preventive safety measures reduce the
risk of starting the tool accidentally, which may result in personal injury .
Removing and Installing the
Magazine and Nosepiece
(Fig . 1, 2, 4, 5, 6, 7, 8)
Install the Nosepiece first then assemble the
Collated or Single Shot Magazine . If the maga-
zine is assembled first, then it will not be pos-
sible to fully insert the Nosepiece .
When working with collated fasteners, install
the Collated Nosepiece 8 and the Collated Mag-
azine 5 .
When working with single shot fasteners, install
the the Single Shot Nosepiece 15 and the Single
Shot Magazine 14 .
1 . Remove the battery pack .
2 . Position nailer onto a flat stable surface .
3 . Remove the Magazine:
a . Rotate the Magazine Release Lever 11
clockwise and pull out the end of the
Magazine 5, 14 to remove from the nailer
(Fig . 4) .
4 . Remove the Nosepiece:
a . Pull the Nosepiece Release Button 9 and
remove the Nosepiece 8, 15 from the
nailer (Fig . 5) .
5 . Insert the Nosepiece:
a . Align the tab of the Nosepiece 8, 15 to
the slot in the housing and push the
Nosepiece into the nailer until the Nose-
piece Release Button locks it in place .
The Nosepiece is properly installed when
you hear a "click" (Fig . 6) .
14
1605A001CD GNB18V-12 202301.indd 14
Assembly
11
Fig. 5
Fig. 6
Click
Fig. 4
5
B
8
9
A
8
Tab
Slot
1/9/23 2:07 PM
Publicidad
