Publicidad
Idiomas disponibles
Idiomas disponibles
User Interface
(Fig . 15)
The User Interface 1 provides the following func-
tions:
a
ON/OFF Button
b
Status Indicator
c
Battery Charge Indicator
d
Reset Button
ON/OFF Button
To switch ON the nailer, press the ON/OFF
Button 1a on the User Interface 1 for 1 .5 sec-
onds until the Warning Indicator 1b and Battery
Charge Indicator 1c lights turn on .
To switch OFF the nailer, press the ON/OFF but-
ton 1a again .
The nailer will switch off after 30 minutes of in-
activity .
Status Indicator
The Status Indicator 1b shows the status of the
nailer . A green light indicates that the nailer is
ready for operation . In case the Status Indica-
tor light color is not green, consult the "Trouble
Shooting" section for further information .
20
1605A001CD GNB18V-12 202301.indd 20
page heading
Operation
Fig. 15
b
a
ON/OFF
Battery Charge Indicator
The Battery Charge Indicator 1c shows the state
of charge of the battery .
LED
5 × continuous green light
4 × continuous green light
3 × continuous green light
2 × continuous green light
1 × continuous green light
1 × flashing green light
Reset Button
The Reset Button 1d is used to reset the nailer
to a normal state after an abnormal condition
is corrected . To reset the nailer, press the reset
button for 3 seconds .
Consult the "Trouble Shooting" section for fur-
ther information on resetting of the nailer .
c
d
RESET
1
Capacity
80–100 %
60–80 %
40–60 %
20–40 %
5–20 %
0–5 %
1/9/23 2:07 PM
Publicidad
