Publicidad
Idiomas disponibles
Idiomas disponibles
Inserting and Removing
the Battery Pack
To Insert the Battery Pack
(Fig . 1, 10)
1 . Set Trigger Lock 3 to the locked position .
2 . Slide charged Battery Pack 17 into the hous-
ing until the battery pack locks into position .
Your tool is equipped with a secondary locking
latch to prevent the battery pack from complete-
ly falling out of the handle, should it become
loose due to vibration .
To Remove the Battery Pack
(Fig . 10)
1 . Press the Battery Pack Release Button 18 and
slide the Battery Pack 17 from the housing .
2 . Press the Battery Pack Release Button 18
again and slide the Battery Pack 17 com-
pletely out of tool housing .
Utility Hook
(Fig . 11)
Do not use the utility hook
or its mounting location for
tether attachments . The utility hook and its
mounting location are not intended to support
tethering loads .
Do not use the utility hook if
it appears damaged or de-
formed . A damaged or deformed utility hook
may result in unstable hanging and the tool un-
expectedly falling, causing property damages
and personal injury .
Install the Utility Hook 16 using the screw in-
cluded with this nailer into the bottom of the
nailer (Fig . 11) .
16
1605A001CD GNB18V-12 202301.indd 16
page heading
Assembly
Fig. 10
18
Fig. 11
16
17
1/9/23 2:07 PM
Publicidad
