Descargar Imprimir esta página

Bosch GNB18V-12 Instrucciones De Funcionamiento Y Seguridad página 18

Publicidad

Idiomas disponibles

Idiomas disponibles

Loading Collated Magazine
(Fig . 12, 13)
When loading the collated magazine, check that
the Magazine Slider 6 slides smoothly . If the
Magazine Slider 6 does not slide smoothly, nails
can be driven at irregular angle or the nailer may
blank-fire .
Use fastener strips that are unbroken and have
fasteners of the same designation .
Loading Instructions:
Do not pull the trigger or de-
press the nosepiece when
loading the nailer . Pulling the trigger or de-
pressing the nosepiece may cause misfiring of
the tool resulting in personal injury and property
damage .
1 . Remove the Battery Pack .
2 . Ensure that the Collated Magazine 5 is free of
debris, such as a build-up of concrete dust .
3 . Install the Collated Magazine 5 and the Col-
lated Nosepiece 8 according to instructions
in the section "Removing and Installing the
Magazine and Nosepiece" .
4 . Position nailer onto a flat stable surface and
point the Nosepiece 8 away from yourself
and bystanders .
5 . Pull the Magazine Slider 6 to the end of the
magazine until it locks in place
6 . Insert collated nail strip(s) 20 with the heads
of the fasteners at the top of the magazine
slot, as shown in Fig . 12 . Confirm that the
nails have slid to the front of the Collated
Magazine 5
.
B
Note: The standard collated magazine can
receive a maximum of 2 nail strips . The ex-
tended collated magazine can receive a max-
imum of 4 nail strips .
7 . While holding Magazine Slider 6 firmly, press
the Magazine Slider Button 7
ly slide the Magazine Slider 6 to ensure nail
strips are secured
Guide the magazine slider
by hand until it reaches its
full forward position . Free recoil of the Maga-
zine Slider can result in damage the follower,
magazine, or cause personal injury .
18
1605A001CD GNB18V-12 202301.indd 18
Operation
.
A
and careful-
C
.
D
Fig. 12
A
Fig. 13
6
C
Note: For best performance use Bosch branded
nails as listed in the "Fastener Selection" sec-
tion .
Dry Fire Lock Out
The nailer is equipped with a Dry Fire Lock Out .
The Dry Fire Lock Out prevents firing when there
are 2 fasteners remaining in the collated maga-
zine .
20
B
6
7
D
7
1/9/23 2:07 PM

Publicidad

loading