AEG BD782S Manual De Instrucciones página 95

Top lamp
Step 1 Turn the glass cover to remove it.
Step 2 Remove the metal ring and clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Attach the metal ring to the glass cover and install it.
Side lamp
Step 1 Remove the left shelf support to get ac‐
cess to the lamp.
Step 2 Use a Torx 20 screwdriver to remove
the cover.
Step 3 Remove and clean the metal frame and
the seal.
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
The appliance does not turn on or does not heat up
Possible cause
The appliance is not connected to an electrical supply
or it is connected incorrectly.
The clock is not set.
The door is not closed correctly.
The fuse is blown.
The appliance Child Lock is on.
Step 4 Replace the lamp with a suitable 300 °C
heat-resistant lamp.
Step 5 Install the metal frame and the seal.
Tighten the screws.
Step 6 Install the left shelf support.
Remedy
Check if the appliance is correctly connected to the
electrical supply.
Set the clock, for details refer to Clock functions chap‐
ter, How to set: Clock functions.
Fully close the door.
Make sure the fuse is the cause of the problem. If the
problem recurs, contact a qualified electrician.
Refer to "Menu" chapter, Submenu for: Options.
ENGLISH 95