Kärcher SE 4002 Manual Del Usuario página 14

Start up
Description of the Appliance
When you unpack the system, check that
everything is complete.
If there are any missing parts or you detect
any transport damage when unpacking,
please inform your dealer immediately.
Note: The front cover pages include pictures
of the appliance and its operation. Please
unfold these first.
Illustration
1 Motor casing
2 Carrying handle
3 Foam filter
4 Filter lock
5 Power cord with plug
6 Storage, power cord
7 Switch for suction (0 / I)
8 Switch for spraying (0 / I)
9 Release, fresh water reservoir
10 Fresh water tank
11 Container
12 Swivel casters
13 Connection for suction hose of the wet/
dry vacuum cleaner
14 Connection, spray hose
15 Spray/suction hose
16 Handle
17 Surrounding air separator
18 Spray lever
19 Lock key for spray mist
20 Lock lever
21 Spray / suction tubes 2 x 0.5 m
22 Storage for suction tubes and accesso-
ries
23 Spray ex floor nozzle for carpet cleaning,
with hard surface attachment
24 Spray ex hand nozzle for upholstery
cleaning
14
English
Attachment for wet/dry vacuuming
25 Attachment for wet/dry vacuuming
26 Floor nozzle with hard surface insert
27 Crevice nozzle
28 Upholstery nozzle
29 Filter bag
Before Startup
Illustration
Remove the fresh water reservoir.
Press the release and remove the tank.
Note: The motor casing can only be re-
moved if the fresh water reservoir was
removed first.
Illustration
Remove the motor casing. For this,
fold the carrying handle forward to un-
latch the reservoir. Remove the acces-
sories and swivel casters from the
reservoir.
Illustration
Turn the container, press in the swivel
casters in the openings at the base of the
container till the end-point.
Illustration
Turn the motor casing around and attach
the foam filter to the filter basket.
Insert the filter cover and turn to lock.
Install the motor casing. Pull up on the
carrying handle to lock.
Illustration
Install the fresh water reservoir. Insert
the bottom part first and then press to-
ward the top on the motor compartment
to check if it is locked in.
Illustration
Attach the suction hose and the spray
hose to the connectors on the appliance.
Note: Press the suction hose tightly into
the connector to lock it into place.
Illustration
Connect the spray/suction pipes and at-
tach to the handle. Center the locking le-
ver when attaching it, turn clockwise to
lock.
Attach the floor nozzle to the spray/suc-
tion pipes and secure with locking lever.