Publicidad
Idiomas disponibles
Idiomas disponibles
The appliance is now prepared for wet
cleaning.
Operations
Always work with an inserted foam fil-
ter - during wet as well as dry vacuum
cleaning!
Wet cleaning of carpets/hard surfac-
es/upholstery
Health risk, risk of damage!
Check the object to be cleaned prior to using
the appliance in an inconspicuous place for
colour fastness and water resistance.
Do not clean water-sensitive floor coverings
such as wood floors (the moisture could
penetrate and damage the floor).
Note
Warm water (max. 50°C) will increase the
cleaning effect.
Wet cleaning of carpeted floors
Use the spray ex floor nozzle.
Work without the hard surface insert.
Please only use the carpet cleaner RM 519
(also effective against foaming in the reser-
voir).
Wet cleaning of hard surfaces
Use the spray ex floor nozzle.
Slide the attachment for hard surfaces onto
the spray ex floor nozzle from the side. The
bristles should point towards the back.
Wet cleaning of upholstery
Use the spray ex hand nozzle.
Fill up fresh water reservoir
Note: You can remove the water reservoir to
fill it or you can fill it directly on the appliance.
Illustration
Flip the reservoir cover up.
Add 100 - 200 ml (volume depends on
degree of contamination) of RM 519 into
the fresh water reservoir, then add tap
water - do not overfill.
Close the reservoir cover.
Start working
Illustration
Insert the mains plug into the socket.
Press the switch for suction (position I),
suction turbine is running.
Illustration
Close fully the surrounding air separator
at the handle.
Illustration
Press the switch for spraying (position I),
the detergent pump is ready.
Illustration
Use the lever on the spray handle to
spray on detergent solution.
Illustration
For continuous spray, the spray lever
can be locked; for this, activate the spray
lever and pull the locking key toward the
rear.
Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
Emptying the reservoir during operation
Note: If the reservoir is full, a float closes the
suction opening, and the appliance works at
a higher speed.
Switch the appliance off by pressing the
switch for suction and spraying
(position 0).
Separate the spray/suction hose and the
spray hose from the appliance.
Note: Possibly remaining water can drip
out, therefore you should place these
into the shower or bathtub.
Remove the accessories and the fresh
water reservoir and unlatch the motor
casing.
Remove the motor casing and empty the
reservoir.
Cleaning tips/mode of operation
– Always work from the light to the shade
(from the window to the door).
– Always work from the cleaned to the un-
cleaned surface.
15
English
Publicidad
