Publicidad
Idiomas disponibles
Idiomas disponibles
Shutting down
Turn off the appliance.
Empty the full reservoir (refer to chapter
"Empty reservoir").
Rinse the reservoir thoroughly with clear
water.
Separate the handle, the spray/suction
hoses and the spray ex nozzle from each
other; open locking lever to achieve this
(centre position),
Flush the accessories separately under
runningn water and let air dry.
Clean the foam filter under running wa-
ter; let it dry before reinserting it.
Leave the appliance open to let it dry.
Storing the appliance. Store the acces-
sories on the appliance and store in dry
rooms.
Maintenance and Care
Risk of injury
Always switch off the appliance and pull out
the mains plug before care and maintenance
work.
Clean the spray nozzle
With an uneven spray jet.
Illustration
Loosen nozzle attachment and pull out,
clean or replace spray nozzle.
Clean the sieve in the fresh water
reservoir
1 x year or as needed.
Illustration
Turn the lock and loosen it. Take out the
sieve and rinse it with water.
Faults
No water exiting from nozzle
Fill up fresh water reservoir.
Check the fresh water reservoir for cor-
rect fit.
Detergent pump defective, contact Cus-
tomer Service.
Spray stream uneven
Clean the spray nozzle of the spray ex
floor nozzle or the spray ex hand nozzle.
Insufficient vacuum performance
Close the surrounding air separator at
the handle.
See diagram 11
Accessories, suction hose or suction
tubes are clogged, please remove the
obstruction.
Filter bag is full, insert a new filter bag
(for the order no. please see the spare
parts list at the end of the present in-
structions).
Cleaning the foam filter
Detergent pump noisy
Fill up fresh water reservoir.
Appliance is not running
Plug in the main plug.
The overheat alarm has been triggered,
please allow appliance to cool down.
17
English
Publicidad
