Publicidad
Idiomas disponibles
Idiomas disponibles
Use only VITO-approved tools for this machine or
technically identical parts. Not doing so may result in
personal injuries or damages to the machine. In case of
doubt, you should contact an official dealer.
For safety reasons, fuel conduction components (hose,
tap, tank, tank cap and connectors) should be checked
regularly to detect any damages and leaks. If necessary,
they should be replaced by an official distributor.
Keep the warning and indication stickers always clean
and legible.
Keep all nuts, bolts and screws tight so that the machine
is able to operate safely.
If components or safety devices are removed for
maintenance work, they must be replaced immediately.
In case of blades replacement, pay attention to the type
of knife and their combination, only versions authorized
by VITO are allowed.
Storage in case of longer stopping periods
Let the combustion engine cool before storing the tiller
in a closed compartment.
Do not store the tiller with fuel in the tank inside a
building. Petrol steam may form and become highly
flammable.
Keep the tiller inside a dry place, with the fuel tank
empty.
If you intend to empty the fuel tank before the winter
season, do it outdoors.
Clean the tiller very carefully before storing it and
ensure it is in an operational state.
Store the tiller with the spark plug pipe removed.
Make sure that the tiller is protected against misuse (for
example, children).
Technical assistance
The tiller must be repaired only by the brand official
technical service or by qualified personnel and only with
original replacement parts.
ASSEMBLY, OPERATING AND MAINTENANCE
INSTRUCTIONS
Check the safety instructions. Remove the spark
plug pipe and wear tight gloves every time you
need to handle the blades.
Assemble and engage the traction and throttle spindles
as described. Incorrectly assembled cables (improper
placement or incorrect lever engagement) may cause
malfunctions.
Perform all described work on a clean, and firm floor.
Respect the assembly positions - always ensure a stable
and safe position of the machine.
Respect the cables assembly instructions very carefully.
Fasten all cable ties to the handlebars in order to avoid
damage to the machine (when folding the handlebar) or
possible anomalies.
ASSEMBLY INSTRUCTIONS
Wheels assembly
Traction wheels
1. Assembly the shaft on both wheels;
2. Engage the wheels shaft on the traction shaft;
3. Engage the pin on the wheel's middle hole and on the
traction shaft hole and then attach the dowel;
Pay attention to the wheel's rotation course.
Pin
Beta key
43
Publicidad
