Vito Agro VIME7 Manual De Instrucciones página 47

Accelerator adjustment knob
With the throttle knob (12), it is possible to adjust the
rotation of the combustion engine.
Regulate the speed between "SLOW" and "FAST"
according to the desired speed.
"FAST"
Engine stop
In an emergency
To stop the engine, place the throttle knob (12) on
"STOP" position;
In regular use
1. Release the traction lever (15) and place the speed
lever (21) on Neutral (Ø);
2. Place the throttle knob (12) on "STOP" position;
3. Close the fuel, place the fuel tap (38) on the left;
MAINTENANCE INSTRUCTIONS
Before any maintenance and cleaning work,
remove the spark plug pipe (37).
Oil check and change
Operating the tiller with a low oil level will cause
severe engine damages.
Place the tiller on a plain floor;
1. Remove the tap (tap with rod) (26);
2. Check the oil level;
3. If the level is low, add oil (15W40) until it reaches the
appropriate level;
Changing the oil:
4. Remove the oil drain (3) and empty the oil;
5. Close the oil drain (3) and fill with new oil;
6. Check the oil level and adjust if necessary;
"SLOW"
"
Gearbox transmission oil check and change
1. Place the tiller on a plain floor;
2. The transmission oil must be leveled with the bottom
limit of the gearbox crankcase (31).
3. If the level is low, add transmission oil (80W90) until
it reaches the appropriate level;
Filter's cleaning
Air prefilter
1. Release the cap and remove the prefilter (10);
2. Blow the filter with compressed air until it gets
completely clean;
3. Place the prefilter and close the cap;
Air filter
1. Remove the butterfly nut and the filter cap (8);
2. Remove the butterfly nut and the air filter;
3. Blow the filter with compressed air until it gets
completely clean;
4. Place the air filter and assemble the other
components in the reverse order of disassembly;
Tap with rod
Drain
Gearbox crankcase
47