Würth DTS 100 Traducción Del Manual De Instrucciones De Servicio Original página 22

Attaching an abrasive (Fig. III)
WARNING !
Risk of severe injuries.
Before changing any parts
¾
disconnect the air supply.
The machine must be switched off
¾
and at a standstill.
▸
Fitting an abrasive.
• The abrasive must lay flat.
▸
Position the support flange [12].
The support flange is fitted correctly when it
3
cannot be turned on the spindle.
▸
Attach the screw and tighten. Keep the spindle
locking knob [2] pressed in to prevent the spindle
from rotating.
Check the correct fastening of the
abrasive.
Danger of injury due to improper
Â
attachment and loss of control of
the device.
Operate the device for at least
¾
1 min in a safe position at idle
speed.
If significant vibration or other
¾
damage is apparent, determine the
cause and remedy.
22
CAUTION !
Operation
Switching on/off (Fig. IV)
WARNING !
Risk of severe injuries
Always guide the machine with both
¾
hands.
First switch on, then bring the
¾
attachment into contact with the
workpiece.
WARNING !
Danger of inadvertent start-up.
Always switch off the machine if the
¾
air supply becomes disconnected.
▸
Press the forward on/off lock [6] and
▸
simultaneously press the ON/OFF switch [5].