Publicidad
Idiomas disponibles
Idiomas disponibles
5 Press and hold
Changing the continuity alert
This setting is used with continuity tests (see
to alert users to the presence of circuit continuities.
Parameter
CONTINUITY
To change the continuity alert:
1 Press
2 Browse to Menu 2 > CONTINUITY, and press
3 Use the arrow keys to change the continuity alert. Select OFF to disable the
4 Press
5 Press and hold
Changing the minimum measurable frequency
This setting is used with frequency tests (see
measurable frequency will influence the measurement rates for frequency, duty
cycle, and pulse width measurements. The typical measurement rate as defined in
the specification is based on a minimum measurable frequency of 10 Hz.
Parameter
MIN-Hz
To change the minimum measurable frequency:
1 Press
2 Browse to Menu 2 > MIN-Hz, and press
Keysight U1273A/U1273AX User's Guide
until the multimeter restarts to return to normal operation.
Setup
Range
SINGLE, TONE, or OFF
for more than 1 second to enter the multimeter's setup menu.
Setup
continuity alert.
to save your changes (or press
until the multimeter restarts to return to normal operation.
Setup
Range
0.5 Hz or 10 Hz
for more than 1 second to enter the multimeter's setup menu.
Setup
Multimeter Setup Options
page
73). The multimeter will beep
Defaul t setting
SINGLE
edit the value.
to discard your changes).
page
100). Changing the minimum
Defaul t setting
0.5 Hz
edit the value.
4
137
Publicidad
