Publicidad
Idiomas disponibles
Idiomas disponibles
The
LPF is enabled, the measurement speed (response time) will be impacted.
The DC Filter cannot be used when the dual display mode is enabled where AC
NOTE
and DC voltages are measured.
Table 4-3
Filter (LPF) options
Measurement
AC/AC+DC
DC
Dual Display
[a] The Filter (DC) will be set to ON as the factory default. You may change it to an alternate setting, and the multimeter will remember the chosen
setting for consecutive uses.
You may enable the Filter for DC coupling of voltage and/or current
measurements. The
Table 4-4
Firmware version 1.64 or older
Parameter
FiLtEr
Table 4-5
Firmware version 1.95 or newer
Parameter
FiLtEr
Keysight U1273A/U1273AX User's Guide
icon appears when either of the LPF circuits are enabled. When either
[a]
DC
OFF
Filter (blocks AC)
OFF
icon will be shown during the measurement.
Range
on or oFF
Range
dC, dCAC, or oFF
Multimeter Setup Options
Fil ter setting
DCAC
Low Pass Filter
Filter (blocks AC)
Low Pass Filter
Defaul t setting
oFF
Defaul t setting
dC
4
OFF
OFF
OFF
OFF
147
Publicidad
