Publicidad
Idiomas disponibles
Idiomas disponibles
Measuring AC or DC Current
Set up your multimeter to measure AC or DC current as shown in
Figure
the display.
Table 2-17
Rotary switch positions allowing current measurements
Legend
Defaul t function
DC A (or mA)
DC µA
Never attempt an in-circuit current measurement where the open-circuit
WARNING
potential to earth is greater than 1000 V. Doing so will cause damage to the
multimeter and possible electric shock or personal injury.
To avoid possible damage to the multimeter or to the equipment under test:
CAUTION
– Check the multimeter's fuses before measuring current.
– Use the proper terminals, function, and range for your measurement.
– Never place the probes across (in parallel with) any circuit or component
Keysight U1273A/U1273AX User's Guide
2-33. Open the circuit path to be tested. Probe the test points, and read
when the leads are plugged into the current terminals.
Making Measurements
is pressed
Function when
Cycles between
– AC A (or mA),
– AC+DC A (or mA)
– % Scale of 4-20 mA (or 0-20 mA), or
– DC A (or mA)
Cycles between
– AC µA,
– AC+DC µA, or
– DC µA
2
Figure 2-32
and
91
Publicidad
