Descargar Imprimir esta página

Maruyama MD7026 Manual Del Usuario página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

・Discharge all of the chemical and fertilizer in the tank so that nothing remains in the tank when spraying is
completed.
・Remove all of the chemical remaining in the tank and return it to the original container or bag and store
the bag or container out of the reach of children. Also wipe off any chemical that has stuck to the
machine. Any chemical remaining in the machine might cause rusting or equipment failure.
・Remove all of the premixed fuel.
・If there is any damage, repair it before storing the equipment. In this case, parts or consumable supplies
should be replaced with the parts specified by the company.
・The equipment must be stored in a place with low humidity where it will not get covered by dust and debris.
Do not run the machine on gasoline only. Be sure to mix the fuel as instructed on Page 19.
Filling of pre-mixed fuel shall be made after the engine has been stopped and has cooled sufficiently. If the
fuel is spilled, wipe it off.
When starting the engine, make sure it is at least 3 meters away from the pre-mixed fuel supply tank.
Follow the 2-cycle engine oil mixture ratio.
Keep away from flame and heat when filling or handling the pre-mixed fuel.
・Do not run the engine in a room as this may cause carbon monoxide poisoning.
・Do not inhale the engine exhaust gas.
・When starting the engine, make sure the shutter lever is at the "0"-position and that the shutter is closed.
・The engine is hot during and directly after running. Touching the muffler, cylinder fins, or other hot parts
will cause a burn.
・Do not touch the spark plug while the engine is operating.
The chemical is discharged at high speed from the spray nozzle, so do not spray it on oneself or other people.
People with long hair should take measures to ensure their hair does not become entangled in the equipment.
The blower is running at high speed and is very dangerous. Never put your hand in front of the suction port
or discharge port during operation.
Starter
Precautions After Operation
Premixed Fuel
Gasoline : Oil
50
: 1
Engine
Blower
Starter
15
Do not remove the screw.

Publicidad

loading

Este manual también es adecuado para:

Md9030