Descargar Imprimir esta página

Maruyama MD7026 Manual Del Usuario página 20

Publicidad

Idiomas disponibles

Idiomas disponibles

● ● ● ● Always use premixed fuel. Do not run the
machine on gasoline only.
Use the oil specified for 2-stroke engines.
Gasoline : Oil
50
: 1
Method of pulling the starting rope.
Grip the starting rope with your right hand.
Press against the chemical tank with your left hand.
Pull the starting rope slowly until you feel resistance.
Pull the starting rope in the direction straight from the
inlet and outlet of the starter.
Do not pull the starting rope all the way out.
Keep hold of the starting rope and return it all the way
to the original position before letting it go.
Toggle switch to "ON" position.
Set the throttle lever 3 to 4 notches.
3 to 4 notches
Toggle switch
PRIMER PUMP
Pump the "PRIMER BULB" under of the carburettor
until fuel can be seen flowing through the "FUEL
RETURN LINE".
Supplying Premixed-fuel
4. . . . Starting the Engine
Starting the Engine
19
The premixed fuel may catch fire.
Fire, such as cigarettes, is strongly prohibited.
Do not fill beyond the reference line.
Fill the oil after stopping the engine.
Take care not to spill the fuel.
If the fuel is spilled, wipe it off completely.
Use unleaded gasoline.
Use the oil specified for 2-stroke engines.
Use at a predetermined mixing ratio.
CHOKE
CHOKE
LEVER
Move the "CHOKE LEVER" fully up ward to the closed
position. If the engine is already warm, only a partial or
open (no choke) choke setting may be required.ne.
START
Pull the "STARTER GRIP" briskly to start the engine.
NOTE: Only short pulls are necessary. Do not pull the
starter cord to its fullest extension. Do not let go of the
starter grip until it is at the fully returned position.
WARM UP ENGINE
When the engine has started, slowly move the
"CHOKE LEVER" fully upward to the open position.
Allow the engine to "WARM-UP" at less than 1/2
speed.
CLOSE
OPEN

Publicidad

loading

Este manual también es adecuado para:

Md9030