Beta 680/3 Manual De Uso E Instrucciones página 17

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
Active From setting
This is the minimum capacity percentage that allows the peak values to be captured in the Click and
Dial modes.
Measurement indications
When a target is selected, the dynatester will indicate if the measured value is low, acceptable or high
compared to the target, in 3 different ways:
1) Text colour (Yellow: Value<Target - tolerance % ; Green: Target - tolerance %≤Value ≤Target +
tolerance % ; Red: Value> Target + tolerance %)
2) Symbol indication (Low =
3) Line indication (F)
Measured value below target lower tolerance limit
Measured value within target tolerance limits
Measured value above target upper tolerance limit
, Pass = √, High =

A) Selected mode indication
B) Set target
C) Measured value
D) Unit of measurement selection
E) Lines corresponding to target tolerance limits (central
line)
F) Indication of value below target lower tolerance limit
G) Indication of Value < Target- tolerance %
H) Direction of application of force
I) Indication of line within tolerance limits
L) Indication of Target - tolerance %≤Value ≤Target
M) Indication of line above target upper tolerance
N) Indication of Value> Target + tolerance %
)

+ tolerance %
limit
EN I
17