Ohyama WOOZOO PC-MA3 Manual De Instrucciones página 40

K
Troubleshooting
State
There is a
➡
sound like
that of water
splashing
Even after
cooking has
➡
finished, it
does not
switch over to
keep warm
Malfunction
➡
error display
E02
Malfunction
➡
error display
E03
Malfunction
➡
error display
E04 E05
E06
Malfunction
➡
error display
E07
➡
Delay Timer
cannot be set
continued
Causes
● There may be drops of
water on the outside of the
inner pot or on the inside
of the main unit
● Selected mode does
not have the keep warm
function
● The lid has not been set in
the proper position
● The temperature sensor
has overheated
● An internal abnormality is
detected
● The sealing gasket is not
installed.
● The pressure release knob
is not correctly set (venting,
sealing)
● Timer function is not
available for the selected
menu.
➡
● Wipe up any drops of water before
setting up the inner pot in place.
● After cooking has finished, it will
switch over to keep warm for only
➡
all the preset menus and pressure
and temperature cook in the manual
mode.
➡
● Set the lid in the proper position (see
page 14) and try again.
● The error display can be turned off
by pressing the keep warm/cancel
button.
● Press the keep warm/cancel button,
➡
open the lid, and cool down for at
least 30 minutes.
If that still does not solve the problem,
then call the Iris Ohyama France SAS
customer service center.
● Stop using, unplug the power plug
➡
from the socket, and call the Iris
Ohyama France SAS customer
service center.
● Press the keep warm/cancel button
to turn off error.
Press the keep warm/cancel button to
➡
open the lid and cool it for 30 minutes
or longer.
If the problem still persists, contact
customer service center.
● The timer can only be used for all
➡
the preset menu and Pressure and
Temperature Cook in the manual mode.
40
PC-MA3
Measures