Publicidad
Idiomas disponibles
Idiomas disponibles
3
Multimeter Features
Making Scale Transfers (Scale)
The Scale operation emulates a transducer by helping you to convert the
measured readings proportionally to the specified ratio and unit display. Use
Scale to transfer voltage readings to proportional readings when using clamp-on
current probes or high voltage probes. The available scale conversions are shown
in the table below.
Table 3-1
Available scale conversions
Scale conversion
[2]
1 kV/V
1 A/mV
1 A/10 mV
1 A/100 mV
[1] The transfer formula used is: Display = Multiplier × Measurement
[2] This value and unit can be adjusted from the multimeter's Setup. See
more information.
1 Press and hold
2 The most recently saved (default: 1 kV/V, ×1000.0) ratio and unit will be shown
3 Press
4 Or, while the
5 Press and hold
110
1000 V/V
1000 A/V
100A/V
10 A/V
on the primary and secondary displays. Press
is flashing to cycle through the available ratio and unit displays.
while the
unit and start the conversion. The selected ratio and unit will be used as the
default ratio and unit the next time Scale is enabled.
3 seconds, the conversion will begin (with the specified ratio and unit shown
on the primary display).
[1]
Mul tiplier
1000.0
1000.0
100.0
10.0
"Changing the user scale conversion value and unit"
for more than 1 second to enable the Scale operation.
symbol is flashing to save the selected ratio and
symbol is flashing, if no activity is detected after
for more than 1 second to cancel the Scale operation.
Keysight U1271A/U1272A User's Guide
Unit
V
A
A
A
while the
Related units
V, kV
A, kA
A, kA
mA, A, kA
on page 149 for
symbol
Publicidad
