Publicidad
Idiomas disponibles
Idiomas disponibles
3
Multimeter Features
Performing event logs (triG)
Ensure that
Event logs are used only with the following modes:
– TrigHold and AutoHold
– MaxMin recording
– Peak recording
Event records are triggered by the measured signal satisfying a trigger condition
set by the measurement function used in the following modes:
Table 3-3
Event log trigger conditions
Trigger cond ition
Modes
The input signal value is recorded:
TrigHold
Each time
AutoHold
When the input signal varies more than the variation count.
When a new maximum (or minimum) value is recorded. The average and present readings are not
MaxMin
recorded in the Event log.
Peak
When a new peak (maximum or minimum) value is recorded.
Start the event log mode
1 Select one of the four modes stated in
2 Press
120
is selected as the data logging option in the multimeter's Setup.
(page
(page
is pressed.
for more than 1 second to start event log mode.
and the log entry number are displayed at the top of the display.
Subsequent readings are automatically recorded into the multimeter's memory
every time the trigger condition specified in
(page
115)
112)
114)
Table
Keysight U1271A/U1272A User's Guide
3-3.
Table 3-3
is satisfied.
Publicidad
