Publicidad
Idiomas disponibles
Idiomas disponibles
Freezing the Display (TrigHold and AutoHold)
TrigHold operation
To freeze the display for any function, press the
If
progress, the display freezes but the data acquisition continues in the
background. Pressing
acquired during the hold.
AutoHold operation
Pressing the
multimeter is not in the MaxMin, Peak, or Data Logging recording modes.
AutoHold operation monitors the input signal and updates the display and, if
enabled, emits a beep, whenever a new stable measurement is detected. A stable
measurement is one that does not vary more than a selected adjustable (AutoHold
threshold) variation count for at least one second (default 500 counts). Open lead
conditions are not included in the update.
Changing the default AutoHold threshold count
1 Press
2
3 Press
4 Press
If the reading value is unable to reach a stable state (when exceeding the preset
NOTE
variation), the reading value will not be updated.
Keysight U1271A/U1272A User's Guide
is pressed while a MaxMin, Peak, or Data Logging recording session is in
for more that 1 second activates the AutoHold if the
for more than 1 second to enter the multimeter's Setup mode.
Setup
should be shown on the secondary display. (If not, press
until it is shown.)
or
to edit the value shown on the primary display.
Dual
E xit
Setup
to save the changes. Press and hold
restarts.
again updates the display to reflect data that was
Multimeter Features
key.
until the multimeter
Setup
3
or
115
Publicidad
