Westinghouse WGen12000DFc Manual Del Usuario página 31

PROBLEM POSSIBLE CAUSE
Frost on the propane If the temperature of the propane tank drops
tank or regulator below the dew point, condensation on the tank
may turn to frost or ice. This typically occurs in
humid conditions.
The Propane tank is not equipped with an
Propane fuel smell
securely sealed.
Propane fuel regulator vent active.
Residual fuel from the carburetor dispersing after
operation.
Poor performance Propane fuel line kinked or crushed.
or engine stalling on
Fuel selector valve not properly positioned.
Propane
Gasoline not purged from the carburetor before
switching to propane.
TROUBLESHOOTING
CORRECTION
Providing all the propane fuel handling equipment is functioning
normally, no correction is needed.
If you suspect your propane fuel tank is not equipped with an OPD
device, discontinue operation immediately and replace the propane
fuel tank with a propane tank equipped with a an OPD.
discontinue operation immediately and return the propane fuel tank
Using a soap solution check each connection and tighten as
needed.
The propane fuel regulator is equipped with a vent that will allow a
small amount of propane fuel vapor to escape from the regulator
when the propane tank valve is opened. This can be normal
providing the venting of the propane is brief. If you suspect that this
is abnormal, immediately discontinue use and have the propane
Normal, no correction is needed.
Inspect propane fuel line and remove kinks or other obstructions.
Rotate the fuel valve fully until the pointer is directly in line with the
desired fuel.
Close the propane fuel tank valve. Move the fuel selector switch to
gas. Start the engine and allow the engine to run until the gasoline
has been consumed in the carburetor. Begin propane start up
procedure.
Westinghouse Outdoor Power Equipment | 31