Publicidad
XZ
x 4
EY
QZ
V
FIG. 15
15) Insert #10 x 1½" Antique Brass Oval Head Screws (EY) through the Table Lock Lever (QZ) and Latch
Support (V) and attach to Table Support (U), centered side to side and about 1/8" from edge of Table
Top (X). With the Lock Lever (QZ) in the closed position, slide the Table Lock Plate (RZ) into position
under the lever and fasten with #5 x 5/8" Brass Flat Head Screws (XZ).
Measure down 5" from end of Table Top (X) and 2½" in from both sides and make a mark. Place out-
ermost hole in shorter flap of Table Leg Hinge (DZ) over these marks and insert a #5 x 5/8" Brass Flat
Head Screw (XZ) in the hole. See FIGURE 15. DO NOT INSERT ALL THREE SCREWS IN EACH
HINGE NOW.
XZ
x 10
FIG. 16
16) With long flap of the hinges up and top of legs flat on the table top, attach hinges to Legs (YY) with
#5 x 5/8" Brass Flat Head Screws (XZ). NOW insert other two screws through the hinge into the table.
See FIGURE 16.
PAGE 10 — 640W
EY
x 2
XZ
U
RZ
DZ
DZ
XZ
XZ
YY
XZ
XZ
XZ
LONG
SHORT
X
XZ
XZ
Publicidad
