Publicidad
VZ
x 4
FIG. 23
23) With drawer right side up, tap Plastic File Rails (TZ) on top edge of File Rail (T) and Drawer End (RB)
with lip to inside. See FIGURE 23.
Install File Bar Clips (VZ) over file rails with longer edge hanging over inside edge. Insert Metal File
Bar (UZ) into the grooves in the file bar clips. See FIGURE 23.
FIG. 24
24) To install drawer and the trays, tilt down slightly and place wheels in cabinet side slides. Raise to level
and push in. See FIGURE 24.
IMPORTANT NOTICE:
If you need to adjust a slide, remove the drawer or tray from the unit to get access to the fixed slide
(cabinet side). Remove the front screw and insert it in the center of the vertically elongated hole of the
slide. Do not fasten screw down tightly. Remove adjacent screw and move slide in desired direction (up
or down). Tighten screw in elongated hole, and insert other screw in a new hole.
XZ
x 2
FIG. 25
25) To install the CD Rack (JY), choose a location for easy access on either side panel and attach with
#5 x 5/8" Flat Head Brass Screws (XZ) through the holes in the rack. To get CDs in the top shelf, it must
have at least 7½" clearance.
PAGE 14 — 640W
T
TZ
JY
Screw Hole
UZ
VZ
UZ
VZ
RB
Publicidad
