Publicidad
CY
x 5
FIG. 6
6) Slide Top Assembly (H) down over the Side Panels (A & B) and Crown (G) and center it. Insert a #8 x 1¼"
Black Screw (CY) into the center hole in the top and fasten into the Crown (G). While pushing the Left
Side Panel (A) against the side of the Top Assembly, insert two #8 x 1¼" Black Screws (CY) through the
Top and fasten securely into the Side Panel. See FIGURE 6. Repeat for the other side panel.
BX
x 24
FIG. 7
7) Measure unit from left top to bottom right ( / ) and from right top to bottom left ( / ). Measurements
should be equal; see FIGURE 7. If line
are equal. If Line
Screws (BX). Birch face of Back should face toward inside of unit and round cord openings should be
toward the bottom of the unit. (Note: The center hole in the middle row of holes in the back does not
receive a screw.)
IZ
JZ
x 2
FY
x 8
8) Attach Corner Brace (KZ) to base and side panels with #8 x 5/8" Pan Head Screws (FY) 1/4" from the
bottom. Screw Adjustable Glides (JZ) into corner brace. Hammer Tack Glides (IZ) into bottom of side
panels about one inch from back edge. See FIGURE 8.
H
CY
CY
B
B
D
/
is longer, tap Side panel (B). Attach Back (III) to unit with 24 #6 x 5/8" Philtruss
x 2
FIG. 8
CY
CY
G
BX
/
is longer, tap bottom of Side Panel (A) until measurements
IZ
IZ
CY
A
III
A
KZ
FY
1/4"
JZ
640W — PAGE 7
Publicidad
