Publicidad
XZ
x 4
YY
FIG. 17A
17) Lay leg assembly flat against the table. Measure 2" up from the bottom of the Leg (YY) on an inside
edge and fasten Magnetic Catch Plate (OZ) to inside of leg. Attach Magnetic Catch (OZ) to bottom of
table so that it makes contact with the catch plate. Use the small screws provided with the catch. See
FIGURE 17A.
To attach the Lid Support (SZ), measure 6" down from top edge of the Table (U) and in 1". Mark this
location for the uppermost screw hole for the lid support. Insert a #5 x 5/8" Brass Flat Head Screw (XZ)
through the lid support into the table. Measure 5" from the end of the Leg (YY) for the upper screw
on the plate and insert a #5 x 5/8" Brass Flat Head Screw (XZ). Now insert the other two screws. See
FIGURE 17B.
FZ
x 1
BX
x 4
18) To attach the Door Skirt (KY) to the Upper Left Door (J), lay the door face down on a protected surface.
Attach the Brass Knob (EZ) with a #8 x 1" Machine Screw (FZ).
Measure in 5/8" from the outer edge and draw a light line. Lay the inner edge of the Door Skirt (KY) on
the line, with the bottom edge flush with the bottom edge of the door. Attach the Skirt to the door with
four #6 x 5/8" Philtruss Screws (BX) through the predrilled holes in the skirt.
OZ
PLATE
OZ
CATCH
EZ
x 1
EZ
FZ
FIG. 18
U
XZ
FIG. 17B
BX
BX
5/8"
YY
XZ
XZ
XZ
BX
BX
640W — PAGE 11
SZ
KY
J
Publicidad
