Publicidad
XZ
x 21
FZ
x 3
HY
x 4
19) Attach Lower Doors (L) to Side Panels (A & B) with #5 x 5/8" Brass Flat Head Screws (XZ). Upper hole
in hinge should go over pre-punched hole in side panels. Attach the Upper Left Door (J) in the same
manner. Attach the middle hinge to the upper left door with three #5 x 5/8" Brass Flat Head Screws (XZ).
See FIGURE 19.
Hang the upper right hand door in the same manner as the other doors, as described above.
Because of the added weight of the table, we recommend that two people do this step.
The elongated holes in the hinges allow for adjustment if the doors are
uneven.
Attach Brass Knobs (EZ) to the installed doors with #8 x 1" Machine
Screws (FZ).
Attach Pads (HY) where doors make contact.
LY
x 2
FIG. 20
20) Level the unit by turning the adjustable glides in the corner braces. The bottom shelf has two holes
near the front for access to the adjustable glides. Insert slotted screwdriver into the slot in top of the
adjustable glide and turn clockwise to raise and counter-clockwise to lower unit. Insert Locking Plugs
(LY) when unit is level.
IMPORTANT NOTICE: Uneven setting of the adjustable glides can twist the unit and cause the doors
to appear out of alignment. Upon selection of the final location of the unit, rotate the adjustable glides
until the unit stands level. If the doors still appear to be out of alignment, the elongated holes in the
hinges allow for adjustment of the doors. Loosening the screws in the side panel will allow the door to
be moved up or down. The hinges on both doors may have to be loosened to align the doors properly.
Align the doors and retighten all screws.
PAGE 12 — 640W
EZ
x 3
L
A
FIG. 19
LY
XZ
These hinge surfaces
must be flush against
the side panel.
J
XZ
EZ
FZ
Publicidad
