Publicidad
WY
x 8
AX
x 8
FIG. 9
9) Install Adjustable Shelves (MB) in desired locations using the Shelf Brackets (WY). The adjustable
shelves should be fastened in place with #6 x 1/2" Undercut Screws (AX). See FIGURE 9.
LZ
x 2
MZ
x 2
FIG. 10
10) Screw the T-Nuts (MZ) onto the Adjustable Glides (LZ) as shown in FIGURE 10. Cover the bottom of
the glides with a cloth to protect them from damage, then lightly hammer them into the Legs (YY). Do
not try to pull the glides out after you have them in place.
Glue two Dowels (PZ) in each end of the Middle Support (W). Spread light layer of glue in the two
dowel holes in each leg and attach middle support to legs. Press firmly together and set aside. See
FIGURE 10.
XZ
x 26
XZ
XZ
XZ
J
11) Attach upper and lower Hinges (CZ) to Doors (J & L) with #5 x 5/8" Brass Flat Head Screws (XZ).
Innermost hole in hinge should go over pre-punched hole in door. DO NOT ATTACH MIDDLE HINGE
TO UPPER DOORS AT THIS TIME. Attach the middle hinge for the left upper door to the Left Side
Panel (A) with #5 x 5/8" Flat Head Brass Screws (XZ). There is a pre-drilled hole in the side panel for
the screw that goes into the upper hole of the hinge. See FIGURE 11.
PAGE 8 — 640W
PZ
x 4
CZ
These hinge surfaces
must be flush against
the doors.
FIG. 11
MB
YY
MZ
LZ
W
MZ
LZ
CZ
XZ
XZ
XZ
L
WY
AX
PZ
CZ
A
Left Side Panel
Middle hinge
for Left
Upper Door
XZ
Publicidad
