U
XZ
x 12
FIG. 12
TOP
12) On the Upper Right Door remove the inner screw from upper and lower door hinges. Place Table Sup-
port (U) so that two holes on one edge line up over the inner screw holes and reinsert the screws. Insert
five #5 x 5/8" Brass Flat Head Screws (XZ) in the holes in the other long side of the table support. Slide
the middle hinge under the table support aligned with the middle hole and fasten in place with three
#5 x 5/8" Brass Flat Head Screws (XZ). Insert screws in the holes in the table support between the
hinges and along top edge. DO NOT INSERT SCREWS IN BOTTOM EDGE NOW. See FIGURE 12.
XZ
x 4
FIG. 13
13) Fasten Table Hinges (BBZ) to the Table Support (U) with #5 x 5/8" Brass Flat Head Screws (XZ) through
the outer holes in the angled piece of each hinge into the pre-drilled holes in the table support. Insert a
screw into the other hole in each hinge. See FIGURE 13.
XZ
x 4
FIG. 14
14) With the wood trim on edge toward top, slide the Table Top (X) under the hinges and center it. Fasten
table top to hinges with four #5 x 5/8" Brass Flat Head Screws (XZ). See FIGURE 14.
XZ
XZ
U
TOP
X
U
TOP
XZ
J
CZ
BBZ
BBZ
U
J
BOTTOM
XZ
XZ
XZ
XZ
BOTTOM
No wood trim
on this edge.
XZ
XZ
XZ
XZ
BOTTOM
640W — PAGE 9