Kärcher Puzzi 8/1 C Manual De Instrucciones página 12

Overview
Quick start instructions
Illustration
1 Connect spray/suction hose to the de-
vice,
Connect spray/suction hose to the elbow
2 Prepare cleaning solution,
Fill up the fresh water tank
3 Select operating mode
4 Cleaning
5 Empty the fresh water tank
6 Empty wastewater container
7 Fill fresh water tank (without detergent)
8 Flush appliance
9 Empty wastewater container
Device elements
Illustration
1 Manual nozzle for cleaning upholstery
(not included in the scope of delivery)
2 Holder for accessories
3 Power cord
4 Cable hook
5 Quick start instructions
6 Switch for spraying
7 Switch for vacuuming
8 Casing
9 Nameplate
10 Steering roller
11 Spray hose connection
12 Floor nozzle for carpet cleaning
13 Carpet adapter
14 Unlocking device of the floor nozzle
15 Suction hose connection
16 Cover
17 Fresh water tank
18 Carrying handle of the device incl. fixa-
tion of suction pipe
19 Suction tube
20 Handle
21 Bender
22 Nozzle mouth piece
23 Union joint
24 Lever on the manifold
25 Spray hose
26 Suction hose
27 Spray/suction hose
12
28 Dirt water reservoir, detachable
29 Carrying handle of the wastewater con-
tainer
30 Seal on the lid
31 Fluff filter
32 Fresh water sieve
 Check high power cable, extension ca-
bles and hoses for damage every time
before use.
Attaching the Accessories
 Attach the suction pipe to the floor noz-
zle and hand-tighten the union nut on
the floor nozzle.
 If required, slide the handle onto the
suction pipe and hand-tighten it in the
desired position.
 Place the elbow over the suction pipe
and tighten the union joint on the elbow
fingertight.
 Insert the suction hose into the suction
hose connection on the appliance.
Attach the coupling of the spray hose to
the spray hose connection of the appli-
ance and snap in place.
 Connect the suction hose to the elbow.
Connect the coupling of the spray hose
with the manifold and snap in place.
Prepare cleaning solution
DANGER
Health risk, risk of damage. Observe all in-
dications on the detergent used.
 Mix fresh water and detergent in a clean
container (use the concentration rec-
ommended for the detergent).
Dissolve detergent in the water.
Note: Warm water (max. 50°C) will in-
crease the cleaning effect. Verify the tem-
perature resistance of the surface to be
cleaned.
Note: For considerate treatment of the en-
vironment use detergent economically.
– 2
EN
Start up