ABB ACS880-14 Guía De Instalación Rápida página 6

6 EN – Quick installation guide
Step
4 Screw in and tighten the insulators to the drive module by hand. Install the T3/W2 connection
terminal to the insulators.
5 Connect the phase T3/W2 conductors to the T3/W2 terminal.
6 Install the T2/V2 connection terminal to the insulators See the warning in step 4.
7 Connect the phase T2/V2 conductors to the T2/V2 connection terminal.
8 Install the T1/U2 connection terminal to the insulators. See the warning in step 4.
EN
9 Connect the phase T1/U2 conductors to the T1/U2 terminal.
10 Remove the plastic sheeting from the output clear plastic shrouds from both sides.
11 Install the shrouds to the drive module.
DA
12 Install the lower front cover to the drive module.
DE
Step
1 Ground the input cable shields (if present) 360 degrees at the cabinet entry.
2 Connect the twisted shields of the input cables and separate ground cable (if present) to the cabinet
ES
grounding busbar.
3 Step drill carefully sufficiently big holes to the entry clear plastic shroud for the cables to the
connected. Align the holes in the vertical direction according to the alignment holes in the shroud.
FI
Smooth the hole edges.
Remove the plastic sheeting from both sides of the shroud.
FR Attach the cables firmly to the cabinet frame to prevent chafing against the hole edges.
4 Put the conductors of the input cables through the drilled holes in the clear plastic shroud.
5 For drive modules without option +H370: Connect the input cable conductors to the drive module
IT
L1/U1, L2/V1 and L3/W1 connection busbars, Go to step 12.
For option +H370: Do steps 6 to 11.
6 Screw in and tighten the insulators to the drive module by hand. Install the L1/U1 connection
NL
terminal to the insulators.
PL
PT
7 Connect the L1/U1 conductors to the L1/U1 connection terminal.
8 Install the L2/V1 connection terminal to the insulators. See the warning in step 5.
RU
9 Connect the L2/V1 conductors to the L2/V1 connection terminal.
10 Install the L3/W1 connection terminal to the insulators. See the warning in step 5.
SV 11 Connect the L3/W1 conductors to the L3/W1 connection terminal.
12 Install the entry clear plastic shroud. Install the front clear plastic shroud and upper front cover.
13 Install the side and top clear plastic shrouds to the drive module.
TR
ZH
Task (motor cables)
WARNING! Do not use longer screws or bigger tightening torque than given in the
installation drawing. They can damage the insulator and cause dangerous voltage to
be present at the module frame.
Task (input cables)
WARNING! Do not use longer screws or bigger tightening torque than given in the
installation drawing. They can damage the insulator and cause dangerous voltage to
be present at the module frame.