Husqvarna 1-8DM Manual De Usuario página 13

3. Remove the separator tray and remove all
contaminations when you fill abrasive or each 3
hours.
4. Install the separator tray again.
5. Fill the separator with abrasive up to the separator
tray. Fill abrasive when necessary.
To connect a dust extractor
WARNING:
extractor if the dust extractor hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
3. Connect the dust extractor hose to the connection
for dust extractor.
To connect the product to a power
source
1. Connect the power plug of the product to a grounded
mains outlet or other power source.
2043 - 001 - 07.02.2023
Do not use the dust
2. Make sure that the mains voltage agrees with the
type plate on the product.
To adjust the height of the handle
WARNING:
the the handle. Make sure that the handle
locks into position. The moving parts can
cause injury.
1. Loosen the 2 lock levers (A).
2. Adjust the handle (B) to an applicable operation
height.
3. Tighten the lock levers to lock the handle position.
To prepare the product for near wall
operation
Only adjust the left handle and wheel to do operations
near a wall. Operate the product in the usual operation
To operate the product on page 14 .
position. Refer to
1. Loosen the bolt to remove the handle.
Be careful when you adjust
B
A
13