Husqvarna 1-8DM Manual De Usuario página 14

2. Attach the handle to the internal side of the
handlebar. Tighten the bolt.
3. Loosen the wheel bolt (A) to remove the wheel (B).
C
4. Attach the wheel to the internal side (C) of the wheel
bracket. Tighten the wheel bolt.
To start the product
1. Connect the product to a power supply. Refer to
connect the product to a power source on page 13 .
2. Start the dust extractor. Refer to the operator's
manual of the dust extractor.
3. Attach the dust extractor hose to the product. Refer
To connect a dust extractor on page 13 .
to
14
B
A
To
4. Set the ON/OFF switch in the ON position.
5. Wait until the ammeter is in idle position.
To operate the product
WARNING:
during operation. Abrasive comes out of the
product at high speed and can cause injury.
1. Fill the abrasive separator with abrasive. Fill the
separator with abrasive when necessary. Refer to
fill the product with abrasive on page 12 .
2. Adjust the handle height for correct operation
To adjust the height of the handle
position. Refer to
on page 13 .
3. Start the product. Refer to
page 14 .
4. Push the product.
5. Pull the abrasive control lever to open the abrasive
To operate the abrasive valve on
valve. Refer to
page 10 .
6. After 7 ft./2 m, close the abrasive valve and stop the
product.
7. Do a check of the blast pattern. Adjust the blast
pattern if necessary. Refer to
pattern on page 15 .
Do not lift the blasthousing
To start the product on
To adjust the blast
2043 - 001 - 07.02.2023
To