Husqvarna 1-8DM Manual De Usuario página 16

4. Turn the control cage (B) clockwise, if the hotspot is
too much on the right side.
5. Turn the control cage (B) counterclockwise, if the
hotspot is too much on the left side.
16
6. Make sure that the hotspot is equaly applied on the
surface for correct adjustment.
7. Tighten the cage clamps when the control cage is in
correct position.
8. Attach the feedspout and put the rubber seal on to
the tube.
A
To stop the product
1. Release the abrasive control lever to close the
abrasive valve. Refer to
valve on page 10 .
To operate the abrasive
2043 - 001 - 07.02.2023