Husqvarna 1-8DM Manual De Usuario página 19

2. Remove the nuts of the blastwheel cover.
3. Remove the blastwheel cover.
4. Put an applicable tool in the blastwheel to prevent
rotation. Remove the bolt.
2043 - 001 - 07.02.2023
5. Remove the blastwheel.
6. Install the blastwheel in opposite sequence.
CAUTION:
when you install a new blastwheel.
To do a check of the V-belt tension
WARNING:
without the V-belt cover installed.
1. Stop the product. Refer to
page 16 .
2. Remove the V-belt cover.
3. Examine the V-belts for damages and wear. Replace
the V-belts if it is necessary.
Always use a new bolt
Do not operate the product
To stop the product on
19