Husqvarna 1-8DM Manual De Usuario página 18

General product maintenance
Empty the dust extractor.
Do a check of the of the abra-
sive separator, the separator
tray and the feedspout.
Clean the product.
Do a check of all safety devi-
ces.
Do a check of the brush seal,
rubber seal and magnetic seal
for wear.
Do a check of the control cage,
blastwheel and liners for wear.
To do before you oper-
Refer to
ate the product on page 9 .
Do a check of the drive belt ten-
sion.
Do a complete servicing and
cleaning of the product.
To clean the product
• Always clean all the equipment after use. Use a
vacuum cleaner.
• Do not use a high-pressure washer to clean the
product.
• Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
To remove and install the control cage
1. Remove the feed spout.
18
Each 3 h Daily
*
X
X
X
X
X
X
12 h after
service
2. Remove the cage clamps and the control cage.
3. Install the control cage in opposite sequence.
To remove and install the blastwheel
1. Remove the feed spout and the control cage. Refer
To remove and install the control cage on page
to
18 .
Each 3
Yearly
months
X
O
2043 - 001 - 07.02.2023