Husqvarna 1-8DM Manual De Usuario página 12

1. Loosen the 2 screws (A) on the 2 sides of the blast
housing that holds the rubber seal.
A
2. Adjust the height (B) of the rubber seal.
3. Tighten the screws.
Abrasive
Speak to your Husqvarna dealer for the selection of
correct abrasive for your surface operation. Refer to
Approved abrasive on page 26 .
Abrasive separator
The abrasive seprator makes the abrasive free from
contamination. The abrasive separator holds the
abrasive and supplies the blastwheel with abrasive.
The separator tray keeps contamination away from the
abrasive and the blastwheel.
12
B
To fill the product with abrasive
WARNING:
protective equipment during operation. Refer
Personal protective equipment on page 6 .
to
1. Make sure that the abrasive valve is closed. Rfer to
Abrasive valve on page 10 .
2. Unlock (A) the cover and open (B) the separator.
A
Always use personal
B
2043 - 001 - 07.02.2023