Hitachi YUTAKI S80 Serie Manual De Instalación Y Funcionamiento página 56

6.3 Setting of DIP switches and RSW switches
6.3.1 Location of DIP switches and rotary switches
6
6.3.1.1 Function of DIP switches and rotary switches

NOTE
• The mark "" indicates the position of dips switches.
• No mark "" indicates pin position is not affecting.
• The figures show the settings before shipment or after selection.
• "Not used" means that the pin must not be changed. A malfunction might occur if changed.
!
DANGER
Before setting dips switches, first turn the power source off and then set the position of the dips
switches. In case of setting the switches without turning the power source off, the contents of the
setting are invalid.
47
PMEN0648 rev.0 - 03/2023