Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
3.
Pass the desired downrod through the decorative cover's centre hole and then introduce
it in the hanging ball again. Make sure the hanging ball is placed in the end with 2 pin holes
and 1 screw hole.
4.
Use the screws provided to tighten back the hanging ball to the rod and insert the stop pin
and stop pin's clip again.
Note
Make sure the stop pin is aligned with the slots inside the hanging ball.
Fig. 5
5.
Loosen the screws and nuts on the top part of the motor housing and remove the pin and
clip from the downrod.
6.
Slide the downrod through the canopy.
7.
Pass the cables through the downrod. To do it more easily, it is recommended to apply
some rated electrical tape on the end to keep them together while passing through
the downrod. Carefully pull from the cables to ensure there is enough cable length to
continue with the assembly.
Fig. 6
8.
Introduce the downrod in the motor housing hole and reinsert the stop pin and stop pin
clip that were previously removed.
9.
Use 2 screws to fix the canopy to the motor housing.
Warning
The important safety precautions and instructions stated in this manual are not meant to
cover all possible conditions and situations that may occur. Bear in mind that common sense
and caution are necessary factors in the installation and operation of this fan.
Fig. 7
Cable connection
The connection cables coming out from the downrod and hanging ball must be connected
according to their colours.
Remote control receiver
Cable instructions
-
Before handling the cables, make sure all the poles are disconnected from the power
supply.
-
The fan includes a remote-control unit with radio frequency, it does not have a speed
control chain. It can only be controlled through the remote control inside the box.
48
ENERGYSILENCE AERO 5290 STONE PRO
ENERGYSILENCE AERO 5290 GOLDEN PRO
Warning
2 people are needed to carry out the cable connection step: 1 person holds the assembled
device while the other one connects the cables.
Canopy assembly
Fig. 8.
1.
Raise the canopy to the mounting bracket, aligning the loosened screws in the mounting
bracket with the holes in the canopy.
2.
Twist the canopy until both screws safely hold the device, reinsert the screws, and tighten
them with a screwdriver.
Note
For safety reasons, it is suggested that 1 person hold the stepladder during this step.
Blade assembly
Fig. 9.
1.
Time saver: washers for blade screws can be set on each blade screw prior to installing
blades.
2.
Align blade holes with motor screw holes, securely tighten all the screws once all the
blades are attached. Before securing screws permanently, repeat with remaining blade
arms.
Note
Tighten the blade screws twice a year.
LED lamp support
Fig. 10.
1.
Unscrew the motor plates' screws and tidy up all the cables. Align the holes on the rear
part of the LED panel with the 3 screws on the motor plate.
2.
Then, screw the 3 screws on the LED plate holes and make sure that the light set is fixed
and does not move.
3.
Place the cover and the lamp back on the LED.
Glass shade assembly
Fig. 11
Restore the cover and the lamp shade back to the LED panel and secure them with decorative
clips and bolt nuts.
ENGLISH
ENERGYSILENCE AERO 5290 STONE PRO
49
ENERGYSILENCE AERO 5290 GOLDEN PRO
Publicidad
