Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
4. OPERATION
-
Use the 5 speed buttons to select the air power level.
-
Press the off button to turn the device off.
-
Use the 2 timer buttons to select the fan operating time: 2 or 8 hours. The fan will turn off
once the selected time has elapsed.
-
Press the light button to turn the fanlamp on and off.
-
Press the light intensity increase or decrease buttons to change the light intensity.
-
The remote control requires 2 x 1.5 V-3AAA batteries.
-
Winter function: if it is cold, press for blades to move hot air stuck close to the ceiling
around.
-
Summer function: if it is hot, press again for blades to create a refreshing breeze.
Warning
Invert the spinning direction of the fan while in operation. Hold down the button for approx. 3
seconds, the device will beep, and the blades will start slowing down until they practically stop
spinning. After a few seconds, they will start spinning again in the opposite direction.
Warnings
-
The remote control operates through RF Wireless digital transmission technology. If both
the fan and the lamp are equipped with switch, turn on the fan at top speed and turn the
light on before using the remote control.
-
If the fan or the light cannot be controlled through the remote control, check if the batteries
in the remote control are in good conditions and if the make good contact, that the positive
and negative electrodes are in the correct position, and if the batteries are charged.
-
If the fan or the light cannot be controlled through the remote control, check if there are
other products with remote control in the same area and check if the transmitter buttons
are pressed. Product with similar remote-control system could cause interference. This
does not include infrared remote controls.
-
Pay attention to the product voltage. Too low a voltage may cause the remote control to
not work. The technical specifications are indicated in this manual.
-
If the remote control is not going to be used for a long time, remove the batteries.
5. CLEANING AND MAINTENANCE
-
Make sure to disconnect the fan before cleaning it.
-
Do not immerse any of the parts of the device in water or splash them with any other liquid.
-
Do not use solvents or any other chemical products for cleaning it.
-
Use a soft, damp cloth to clean the surface of the device.
50
ENERGYSILENCE AERO 5290 STONE PRO
ENERGYSILENCE AERO 5290 GOLDEN PRO
6. TECHNICAL SPECIFICATIONS
Model: EnergySilence Aero 5290 Stone Pro/EnergySilence Aero 5290 Golden Pro
Product reference: 05982/05983
40 W, 220-240 V ~ 50/60 Hz
24 W (max.) LED
Description
Fan maximum flow
Fan power consumption
Service value
Power consumption on standby mode
Fan sound power level
Maximum air speed
Service value measurement standard
Contact details to obtain more information
This product features a light source with an energy efficiency grade F.
Made in China | Designed in Spain
Technical specifications may change without prior notification to improve product quality.
7. DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES
This symbol indicates that, according to the applicable regulations, the
product and/or cells must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should
dispose of the batteries/accumulators and take them to a collection point
designated by the local authorities.
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of old appliances and/or their batteries.
Compliance with the above guidelines will help protecting the environment.
ENGLISH
Symbol
Value
Unit
F
160.5
m
/min
3
P
33.8
W
SV
4.8
(m
/min)/W
3
P
0.5
W
SB
L
50
dB (A)
WA
C
2.6
m/seg
IEC 60879
Cecotec Innovaciones S.L.
C/ de la Pinadeta s/n, 46930
Quart de Poblet, Valencia (Spain)
ENERGYSILENCE AERO 5290 STONE PRO
51
ENERGYSILENCE AERO 5290 GOLDEN PRO
Publicidad
