Publicidad
Idiomas disponibles
Idiomas disponibles
14
SECTION 5: UV LAMP INSTALLATION
Purpose
To instruct the operator how to properly install the UV
lamp(s).
Frequency
Lamp installation in new unit or lamp replacement
change-out (after every 12,000 hours of continual
operation).
Parts and Required Equipment
• UV Lamp(s)
• Adjustable Wrenches
• Cotton or Silicon Gloves
• Personal Protective Equipment
General risk due to electricity.
UV Lamps are fragile and potentially dangerous
if broken. Handle with care.
Procedure
IMPORTANT: Before installing the UV Lamp(s) a
MANDATORY WATER TEST must be performed.
See Page 13.
NOTE: Use clean cotton or silicon gloves when handling
the UV lamp(s). Skin oils absorb ultraviolet light
and reduce UV intensity. Skin oils may also lead
to premature lamp failure.
2. Gently slide the UV Lamp into the Quartz Sleeve
Retaining Nut leaving 6" of the UV lamp exposed.
BioShield® PRO UV System Installation and User's Guide
3. Loosen (not remove) the lamp Water Tight Connector
nut (2) to release tension on the lamp cable allowing
the cable to slide freely through the adapter. This will
allow the male-threaded body (3) portion of the lamp
Water Tight Connector to be threaded into the white
quartz sleeve retaining nut without twisting the lamp
cable (after lamp installation).
4. With the UV lamp installed inside the quartz sleeve
and six inches exposed, attached the lamp cable's
stepped 4-Pin Connector on to the four pins of the
UV lamp.
5. With the lamp cable/lamp connection complete
gently slide the remainder of the lamp w/ cable
through the Quartz Sleeve Retaining Nut and into
the quartz sleeve. With the lamp now inside the
quartz sleeve, gently continue to push the lamp (w/
connected lamp cable) into the quartz sleeve until it
stops, then pull out 1/2" of the lamp cable. This will
position the lamp properly inside the quartz sleeve
avoiding heat damage to the Quartz Sleeve Module
Faceplate and Quartz Sleeve Module.
6. With the UV lamp in its correct position inside the
quartz sleeve, thread the water tight connector into
the Quartz Sleeve Retaining Nut.
7. With the "black" Water Tight Connector threaded
into the Quartz Sleeve Retaining Nut, tighten the
Cable Adapter Nut (2) to create a watertight seal on
the lamp's cable. Take care not to bend or damage
the Water Tight Connector's "gasket prongs" during
this process.
8. The UV lamp is now properly installed.
Publicidad
