SAKAWA 1G52 Manual De Usuario página 101

Gasoline and oil are dangerous, avoid contact of gasoline or oil with skin and eyes. Do not
inhale or swallow them. In case of ingesting fuel and / or oil go quickly to your doctor. If you come
into contact with fuel or oil, clean yourself with plenty of soap and water as soon as possible,
if you feel irritated eyes or skin afterwards consult immediately with
a doctor.
IMPORTANT: Fuel and oil are highly flammable. Si el
Fuel , oil or machine ignite Put out the fire with a dry powder extinguisher.
Gasoline and oil are extremely flammable and explosive under certain conditions. Do not smoke
and do not bring flames, sparks or heat sources close to the machine.
Add fuel before starting the machine. Never remove the fuel cap while the engine is running
or when the machine is hot.
Make sure the gas cap is properly closed while using the machine. Make sure to close the gas
cap properly after refueling,
Always store fuel and oil in approved containers that comply with European regulations.
Do not use fuel that has been stored for more than 2 months. Fuel stored too long will make it
more difficult to start the machine and will result in unsatisfactory engine performance. If the
fuel has been in the tank of the machine more than two months, remove it from the machine
and replace it with one in perfect condition.
Use and care of this machine.
Use this machine only for aerating ground areas. Do not use this hoe for other unintended
purposes. The use of this machine for operations other than those planned may lead to dangerous
situations.
Use this machine, accessories, tools, etc. in accordance with these instructions and in the
manner provided taking into account the working conditions and the work to be developed. The
use of this machine for applications other than those intended may cause a dangerous situation.
Verify that all security features are installed and in good condition.
Remember that the machine operator is responsible for hazards and actions caused to other
people or things. The manufacturer shall in no case be liable for damage caused by improper
or incorrect use of this machine.
Do not force this machine. Use this machine for the right application. Using the right machine
for the type of work to be done will allow you to work better and safer.
Before starting to work with the machine, check that the milling cutters are not in contact with any
object and that they can be moved freely.
Do not use this machine if the switch does not switch between "closed" and "open". Any machine
that cannot be controlled with the switch is dangerous and must be repaired.
Keep this machine. Check that the moving parts are not misaligned or locked, that there are
no broken parts or other conditions that may affect the operation of this machine. Whenever
101