Publicidad
Idiomas disponibles
Idiomas disponibles
Mixture of gasoline and oil.
Use unleaded 95 octane gasoline and synthetic oil for two-stroke engines. Motor fuel: Mix
synthetic oil and gasoline (Gasoline 40: oil 1= 2.5%).
Mix gasoline and oil in a CE approved container.
Do not use fuel that has been stored for more than 2 months. Fuel stored too long will make it
more difficult to start the machine and will result in unsatisfactory engine performance. If the
fuel has been in the tank of the machine for more than two months, remove it from the machine
and replace it with one in perfect condition.
Refueling in the machine:
1. Choose a suitable zone to perform this operation.
2. Shake the container in which you have the mixture of gasoline and oil already prepared.
3. Remove the fuel cap and refill with the gasoline-oil mixture.
4. Close the fuel tank cap tightly and remove any fuel that may have been spilled on the outside
with a dry cloth.
WARNINGS:
Stop the
engine before refueling, disconnect the spark plug and wait for the muffler to cool
down.
Never perform this operation in an enclosed or unventilated place. Separate at least 3 meters
from the area where you have refueled before starting the machine. Do not remove the fuel cap
while the engine is running.
Putting in macrha and stop.
Before starting the machine make sure that the moving parts of the machine are not in contact
with any object.
Cold
the engine.
starting
1. Tighten the carburetor priming pump several times (7 to 10 times) to ensure that the fuel
has reached the carburetor.
2. Set the air lever to the CHOKE (OFF) position.
3. Hold the motor hoe with your left hand on the handlebar and pull the starting string until the
engine explodes or starts.
108
Publicidad
