SAKAWA 1G52 Manual De Usuario página 107

Installation of the handlebar.
upper
Install the top handlebar (A) by inserting the screws (B) with the washers (C) and screw the
knobs with nut (D ) tightening tightly.
Installation of the depth spur.
1. Place the spur (A) at the desired height.
2. Insert the pin (B).
3. Hold the pin with the crane (C).
Installation of the throttle .
cable
Insert the cable head into its location on the throttle lever.
Installation of the on/off switch
cable.
Connect the two terminals
Checkpoints before commissioning .
Check the machine for loose parts (screws, nuts, housings, etc.) and damage. Tighten, repair
or replace parts that you have found in poor condition. Make sure there are no leaks or oil leaks
. Do not use the machine if it is damaged or incorrectly adjusted. Make sure the safety guards
are properly installed and in perfect condition.
Installation of the height of the depth spur.
Before starting the machine, adjust the height of the depth spur to the desired working height.
107