SAKAWA 1G52 Manual De Usuario página 106

Assembly.
Bill of Materials.
This machine includes the following items that you will find inside the box:
• Motor assembly and cutting milling cutters.
• Top handlebar .
• Upper handlebar fastening screws (x4).
• Upper handlebar clamping moths (x4).
• Upper handlebar fastening washers (x4).
• Lower handlebar .
• Lower handlebar fastening screws (x2).
• Lower handlebar fastening nuts (x2).
• Cable clips (x4).
• Shooting.
• Pin and draft clamping group.
• Instruction manual.
Assembly.
Insert the tips of the lower handlebar (A) into the grooves between the motor (B) and the guard
(C).
2. Place 2 cable clips (D) on the screws (F).
3. Insert the screws (F) on the right side of the machine through the holes in the lower
handlebar until the tips come out through the holes in the lower handlebar on the lower
handlebar left of the machine.
4. Place 2 cable clips (D) on the tips of the screws on the left side.
5. Install the nuts (E) on the screws (F).
6. Place the ON/OFF switch cable on the left side of the machine by holding it by the cable
clips (D).
7. Place the throttle cable on the right side of the machine by holdingit or by the cable clips (D).
8. Tighten the nuts (E).
106