SAKAWA 1G52 Manual De Usuario página 109

4. Place the air lever in the RUN position (ON - Normal Working Position).
5. If the machine has not started (you have only heard an explosion) pull the starter string again
until it starts.
6. Allow the engine to warm up for a few minutes before starting to use the machine.
Hot start of the engine .
In case the machine is hot, make sure that the air lever is in the RUN (ON) position and pull
the starter string until the starter starts the
engine.
If after a few attempts the machine does not start follow the starting steps with the engine cold.
Engine shutdown.
Stop accelerating and let the engine idle for half a minute. Turn off the engine by pressing
the switch.
Commissioning.
Use this machine only for the uses for which it is designed. The use of this
A hoe for any other use is dangerous and may cause damage to the user and/or the machine.
Do not approach the milling cutters of the hoe when the engine is running.
If you slip or lose your balance or fall, release the accelerator trigger immediately.
Do not rely solely on the safety features of this machine.
Do not use this machine if you are fatigued, sick, have taken medicines, narcotics, or alcohol.
Lack of rest and fatigue can lead to accidents or damage.
Do not use this machine at night, in fog or with reduced visibility that does not allow you to see
the work area clearly.
Limit the continuous use time of this machine to 10 minutes and rest between 10 and 20 minutes
between each session.
Work with the machine at an appropriate pace that allows you to walk. Do not run while working
with the machine.
Never leave this machine unattended.
Do not allow anyone to enter the working perimeter. This working perimeter must be 15 meters
and is a dangerous area.
Clean the work area and remove all obstacles that may lead to accidents.
109