Publicidad
Idiomas disponibles
Idiomas disponibles
Wipe the bottom of the transmission case around the milling cutters and the protective shield
with a brush.
Never use water or other liquids to clean the machine. Wipe the rest of the
machine with a damp cloth.
Periodic
maintenance
Perform regular inspections on the machine to ensure efficient operation of the machine. At
least once per session take your machine toservice for complete maintenance.
Cleaning the air filter.
Dirt on the air filter will cause a reduction in the machine's performance. Check and clean this
item. If you notice damage or alterations to the filtro, replace it with a new one.
Note: The engine should never run without the air filter installed.
Carburetor
.
setting
The adjustment of the carburetor is complicated and should only be done by the technical
service.
Fuel filter .
The fuel tank is equipped with a filter. This is located at the end of the fuel suction pipe and can
be removed with the help of a hook-shaped wire .
Check the fuel filter periodically. Do not allow dirt to enter the fuel tank to prevent the filter
from getting dirty. A dirty filter will make it more difficult to start the engine and produce
anomalies in the operation or stop of the engine.
Check the combustible. If you notice dirt replace it.
If the inside of the fuel tank is dirty you can clean it with gasoline.
Spark plug verification.
The most common problems when starting a machine are caused by a dirty or bad spark plug.
Clean the spark plug and check it regularly. Verify that the distance between electrodes is correct
(0.6 - 0.7 mm).
Cleaning the cylinder fins
The cylinder fins are responsible for cooling the engine thanks to its contact with air. These fins
must always be clean and without any material between them that limits the passage of air. Dirty
fins will cause the engine to overheat and may seize. Regularly check the condition of the
cylinder fins.
.
Filter cover clamping screw
.
112
Publicidad
