SAKAWA 1G52 Manual De Usuario página 111

Maintenance and Service.
Removal of safety devices, improper maintenance or replacement of
Parts with non-original spare parts can cause severe bodily injury.
Do not change machine control mechanisms or engine speed limitations to increase engine
speed.
The goal of maintenance and service is to ensure that your machine always operates in the best
conditions of safety and efficiency.
maintenance periods in this manual.
It is always necessary to turn off the engine, disconnect the spark plug and verify that the cutting
tool is stopped before cleaning, transporting or modifying the cutting tool . Before performing
any maintenance on the machine or repair make sure the engine is stopped and remove the
pipe from the spark plug. Read the instruction manual before performing any operation on the
machine.
WARNING! Do not modify the machine or cutting elements. Improper use of these items may
result in SERIOUS PERSONAL INJURY OR DEATH.
Keep the machine clean, especially the fuel tank area and the areas near the air filter. To reduce
fire hazards, keep the engine, muffler and area around the fuel tank clean, free of vegetation
or grease.
Never attempt settings on the machine if the machine is running. Carry out all maintenance of
the machine with it placed on a flat and clear surface.
Always use suitable spare parts in order to obtain adequate product performance and avoid
damage and risks to machine and user. Spare parts must be purchased from the dealer's
technical service. The use of other spare parts can cause risks, damage to the user, the people
around and the machine.
Do not adjust the carburetor. If necessary, take your machine to service . The setting of the
Carburetor is complicated and should only be done by the technical service. Incorrect adjustment
of the carburetor may cause damage to the engine and shall be grounds for warranty cancellation.
Maintenance after work.
Perform the following maintenance and care operations when you finish working with the
machine to ensure the proper functioning of this machine on future occasions.
Genetic .
check
- Check that the burs are securely attached to transmission.
strawberries.
- Check the cutting edge and condition of the strawberries. Sharpen or replace strawberries
when necessary. It is recommended that these operations be carried out in a technical service.
Cleaning of the milling cutters and the machine.
Attention! Always clean the machine after use. Failure to carry out proper cleaning can cause
damage to the machine and cause it to malfunction.
Attention! Strawberries are sharp and can cause damage. Wear protective gloves when cleaning
the machine.
Follow the recommended recommendations and
111
Tighten, if necessary, the